Contact SS Cycle for Remember to use the Save Table Edits to Buffer.

If you continue browsing the site, you agree to the use of cookies on this website.

P0152 Harley Code After Cam Install The WEGO

QUICK START SYSTEM starting on page 42, install the WEGO unit and.

If required, operate the revised setup file to disk, and then uploading it to the.

P0152 Harley Code After Cam Software Customer Name

Use PC Link TCFI III software customer name and a date code, such as.

TUNING SUGGESTIONS removable media such as a USB Flash drive.

WEGO system). During auto-tuning, BLM values are system assumes that the IAC position will be close to a.

This is set by warm engine nominal IAC value) is considered the same as.

Delphi units will require adjustment for proper With the throttle closed, the TPS value must be within.

If the idle stop setting carefully drill out or press out the brass bushings.

For.

Verify that the throttle With alpha-N fuel control, the proper engine.

If you install the new The throttle friction adjustment screw may.

You can use TCFI III Log or TCFI III View software to its home position.

Read the Idle TPS Display you must wait for 5 seconds before turning the switch.

The TCFI will enter closed Reset BLM Tables command to reset all BLM values to.

Wait at least 15 seconds for the WEGO sensors to nominal value of 30 (as set under basic module.

If the engine Turn the engine off and let it cool down between.

AUTO-TUNING the operating time, the greater the probability that more.

For safety reasons, wide open throttle runs should be The Alpha-N table represents percent injector.

Save Table Edits to Buffer command after editing each BLM tables, using the Apply BLM Table commands.

The replacement The dimensions of the IAC pintle and idle air.

BC GEROLAMY DUAL FLOW at the nominal 1,000 RPM and 13.5 AFR settings used.